10/100/1000base-t to sfp media converter (13 pages)
Summary of Contents for D-Link DFE-855
Page 1
(please refer to the section entitled Connections Communication Mode). Diagnostic LEDs on the DFE-855 provide indication of power, linkage and data reception. Network Cables Supported The connectors and network cables supported by the converter are listed in the following table:...
Page 2
Fiber SC 100BASE-FX 1300nm 62.5/125, 50/125-um Multimode fiber
Fiber Optic
Converter • Conforms to the IEEE 802.3u 100BASE-TX and 100BASE-FX standards. • 100Mbps data transfer rate. Supports transmission distances of up to 2 km •...
Page 3
The DFE-855 converter features the following LED indicators: TX Link/Rx Indicator (green) Steady green indicates that a valid link exists. Flashing green indicates that the converter is receiving data from the RJ-45 connector. PWR Indicator(green) Lights when power is on.
Page 4
100BASE-FX port is connected to the DFE-855's SC jack through a fiber-optic cable; and the supplied AC power adapter is connected to the DFE-855's DC power jack. The figure shows the maximum possible distance between the two devices: 2,100 meters. Note that the network ports on...
Page 8
Appendix C RJ-45 Pin Specifications. The following diagram and table show the standard RJ-45 connector and their pin assignments. The standard RJ-45 connector
"#$%!&' "#%!&' )#$%' * * )#%' * *...
Page 9
Pinout descriptions for straight-through and crossover cables are shown in the following figures.
Need help?
Do you have a question about the DFE-855 and is the answer not in the manual?
Questions and answers