Bosch D9412GV2 Operation And Installation Manual page 89

5.0 Mounting and Setup
Mount the Detector
• After verifying an acceptable
location, permanently mount
the detector. The detector can
be mounted using the one
center screw or with two
screws for more stability. If
mounting using the center
screw only, the circuit board
does not need to be removed.
If mounting using two screws:
- Remove the circuit board from
the enclosure by pushing back
the two retainer tabs and lifting
out the circuit board.
- Use the two mounting holes in the enclosure to secure it to the
mounting surface.
- Replace the circuit board.
Install Wiring
CAUTION:ONLY APPLY
AFTER ALL CONNECTIONS
HAVE BEEN MADEAND
INSPECTED.
NOTE: Do not coil excess wire inside the
unit.
NOTE: For Canadian installations, install
in accordance with the Canadian
Electrical Code.
Select LED Latching Mode
ON: The LED will latch on when the unit is alarmed and will stay on until
it is reset. Momentarily interrupt input power to reset the LED.
OFF: The LED will not latch after an alarm.
NOTE: If the jumper is removed or missing, the LED Latching Mode
will default to OFF.
Setup and Testing
• Replace the detector's cover, install tamper screw (if desired), then
apply power.
• Re-test the unit with the DS1110i Glass Breakage Tester.
Automatic Sound Check
• This detector features Automatic Sound Check, to allow the end
user to test the unit on a periodic basis. To perform the test, simply
clap your hands or create some other loud sound. When the detector
hears this sound the LED (but not the alarm relay) will activate. This
feature works in the normal operating mode and does not require
that the detector be in the test mode.
The DS1101i/1102i/1108i are protected by the following patents:
#5,450,061 and #5,438,317.
DS1101i, DS1102i, DS1108i Installation Instructions
Wire Entrances
-
+ NO C NC T T
LED
Latch
OFF ON
POWER
DS1101i and DS1102i wiring
1 2 3 4
– +
Voltage In Alarm
DS1108i Wiring
1 2 3 4
– +
Voltage In Alarm
Off
Cover
Tamper
5 6 7
Tamper
5 6
Tamper
On
© 2007 Bosch Security Systems, Inc. Page 3