Check List Of Step-By-Step Guides To Install - Kenmore ULTRASOFT 250 625.38826 Owner's Manual

_ii_'_!!_!i_i_ii_i SECTION 1 _i_d_J!ii_,_iii_i_'iil
WATER SOFTENER START UP
B. CHECK LIST OF STEP-BY-STEP GUIDES TO INSTALL
To be sure you have done all the steps to install the
softener, read the following list. Refer to the Installa-
tion Manual, part no. 7258997, for step-by-step
guides.
Page numbers referred to are in the Installation
Manual unless otherwise noted.
_-" Is the house water flow going INTO the softener
valve INLET? Trace piping to be sure. See pages
2-4 and 2-5.
Is the plumbing bypass valve (or 3 valves) set for
SERVICE? Bypass valve(s) should always re-
main in soft water service position. Position in
"bypass" only if needed for softener repairs. See
FIG. 14, page 4-1 of this manual.
_," Is the valve drain hose connected the right way,
and without sharp bends or kinks that could
stop or reduce water flow? See page 3-5 in the
installation manual.
INLET
Page numbers referred to are in the Installation
Manual unless otherwise noted.
_" Is the transformer plugged into an inside, al-
ways live, grounded, 120V-60Hz electrical out-
let? See pages 3-8 and 3-9 in the installation
manual, and the wiring schematic on page 5-1 of
this manual.
_-" Be sure to restart the water heater. See page
3-9.
plastFc
JI
3-valve t P-_-r_. !
Bypass Valve(s)
NOTE: Codes in the state of Massachusetts require installation
by a licensed plumber. For installation, use plumbing code
248-CMR of the Commonwealth of Massachusetts.
1-2
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line