Rotary Valve Service; Disassembly; Servicing The Valve; Assembly - Kenmore ULTRASOFT 250 625.38826 Owner's Manual

_,iii_i_._ii_,_iiJi_'i SECTION 5 !_ii!!!i!_ii_i!i_iiii!!_
SERVICE TECH. INFORMATION
B. ROTARY VALVE SERVICE
Before working on the valve, turn off the water sup-
ply and disconnect from electrical power. TO RE-
LIEVE PRESSURE:
• 3 VALVE BYPASS: Close the inlet valve and open
a soft water faucet. Then close the outlet valve and
open the bypass valve.
• SEARS
SPECIAL BYPASS: Slide the bypass valve
stem to bypass position. Loosen three hex head
screws toward the back side of the valve to allow
pressure water to bleed out. Catch water with a rag.
Then, turn the rotor (clockwise only) to service posi-
tion. Tighten the screws using a criss-cross pattern.
If a torque wrench is available, torque to 3040 inch
pounds. Do not over tighten.
Lubricate the gear on the motor, and the valve cam
gear with Molykote grease, or other high quality
gear lubricant.
Be sure to orient switch as shown, with lever toward
the cam.
DISASSEMBLY
To remove a part or group of parts, refer to the valve
drawing. A common screwdriver or nut driver,
Phillips screwdriver and pliers are the only tools
needed to completely disassemble.
SERVICING THE VALVE
Inspect all o-rings, seals and gaskets for wear or de-
fects.
Inspect the bottom surface of the rotor for scratches,
chips or wear.
Note:
If replacement is needed, be sure to use the current
replacement part.
ASSEMBLY
Be sure all parts are in place and in the proper posi-
tion. Lubricate ALL o-rings and seals with FDA ap-
proved sihcone grease. To install the rotor seal, first
place the seal into the valve groove, rounded side
down (see cross-section). Apply a hght coating of
siheone grease to the seal's crossing ribs. Then, care-
fully center the wear strip on the seal, and push it
downward onto the seal.
Install the nozzle and venturi seal and drain seal.
Assemble wave washer bearing, the wave washer,
and two o-rings onto the rotor top shaft. Then center
the rotor in the valve body, on the rotor seal.
Lower the cover onto the valve body and rotor shaft.
Then install the cover holding screws. Before tight-
ening the screws, install the valve cam and gear.
o-nng seals _
wave washer -..._..._
q
rotor&disc
see Nozzle
assembly
service,
page 3- 2
motor
motor plate
o- ring
/ rotorseal
_S drainseal
nozzle&venturi seal
5-5
Problems, Questions? Call 1- 800- 426- 9345 Kenrnore Water Line