Program - Kenmore 625.34857 Owner's Manual

SECTION 1 WATER SOFTENER START-UP
I I
lC. PROGRAM THE TIMER
signal light adjust
f
salt level adjust
LEVEL LEVEL
display SELECT button
\
UP button
\
/
DeluxeDemand Water Softener
KenmoreWaterLine
for CustomerAssistance
1-800-425-9345
_ RECHARGE TONIGHT
_o_ _ .EC.A.GE NOW
l
/ \
ON/OFF-HOLD button DOWN button
(Recharge Tonight-Now)
with Dual Segment Electronic Display
,J
When the transformer is plugged in, the model code
SR31, and a test number (example: k]0) show in the
face plate display for 4 seconds. Then, 12:00 AJ4 and
PI_SE]VT TIME begin to flash.
I1 I1-1
I\ ILl
I -I,1-11-1aM
I L-'LIU
PRESENT TIME
NOTES:
If SR- - shows in the display, press the UP _{] or
DOWN[_button until SR31 shows. Then, press the
SELECT button to set, and change
tO
the flashing
PRESENT TL'FIEdisplay.
To check the model code, unplug the transformer at
the wall outlet and plug in again, if other than SR31
shows, see page 18 to reset.
SOUND "BEEPER": A "beeper" sounds while
pressing buttons for timer set-up. One beep signals a
change in the face plate display. Repeated beeps
mean the timer will not accept a change from the
button you have pressed, telling you to use another
button. For example, while setting the hardness
(step 2), the beeper sounds repeatedly when the
display reaches ] using the DOWN button, or the
highest hardness setting using the UP button.
1. SET PRESENT TIME OF DAY:
NOTE:
If the words PRESENT TIME do not show in the
display, press the SELECT button (FIG. 1) until they
do, or see the previous
notes.
• Press the UP / DOWN buttons
to set the present
time. Press UP
tO
move the display ahead; press
DOWN
tO
move the time backward.
If the present time is between
noon and midnight, be sure PM
shows.
I_,1- I-I m
' DO
PRESENT TIME
I I,-II- AM
i /,_nO
PRESENT TIME
If the present time is between
midnight and noon, be sure AM
shows.
NOTE:
Each press of the UP /DOWN buttons changes the
time by ] minute. Holding the buttons in changes the
time 32 minutes each second.
6