Dimensions/Specifications - Kenmore 625.34857 Owner's Manual

SECTION 4 OTaER T a,.GS TO K.OW
I I
4A. DIMENSIONS/SPECIFICATIONS
BYPASS VALVES
F
SINGLE-PLASTIC
OUTWARD
FOR
Bypass
SINGLE-BRASS
Push
q;. ,
For SH
Bypass [INWARD
I FOR
[SERVICE
3-VALVE
SE_RVICE
Close Bypass Valve
Open Inlet & Outlet Valves
BYPASS
Open Bypass Valve
Close Inlet & Outlet Valves
Outlet
Valve
Bypass
Valve
i Inlet
Valve
A
l / -----'\,
/ \
I
I
I
I
I
_B-4
\ /
C
i
i
E
INCHES ClVl
A Salt Tank Height 40-1/4 102.2
B Resin Tank Diameter (nominal) 9 22.7
C Resin Tank Height (nominal) 40 101.6
D Inlet-Outlet Height 41-1/2 105.4
E Overall Height 46 116.8
F1 Length 19-1/2 49.5
F2 Width 16-1/2 41.9
-- Distance between inlet-outlet 3-3/8 8.6
center lines
TIMER SR CODE SR31 MODEL NO. 625.348570 AND 625.348590
NOTE: Please see the rating decal for water softener operating capacity, salt usage and se:_rice flow rate/pres-
sure loss performance specifications. Performance specifications are validated by the Water Quality Associa-
tion (WQA). The rating decal is located on the rim, under the salt hole cover (see page 28).
WATER SUPPLY TO WATER SOFTENER
MINIMUM WATER SYSTEM FLOW (gpm) 3
MINIMUM-MAXIMUM WATER PRESSURE (psi) 20-120
MAXIMUM WATER TEMPERATURE (°F) 120
MAXIMUM WATER HARDNESS (gpg) 110
MAXMUM "CLEAR WATER" IRON (ppm) 7
SALT FOR WATER SOFTENER
TYPE OF SALT NEEDED Nugget/Pellet
ALTERNATE TYPE OF SALT Pure, evaporated, compacted
water softener salt
STORAGE CAPACITY (pounds) 200
OTHERS
TYPE OF ION EXCHANGE MATERIAL (resin) High Capacity
AMOUNT OF RESIN (cu.ft.) 1.0
REGENERATION (RECHARGE) CYCLE TIME (min.)
FILL 2.7-10.3
BRINING/BRINE RINSE 97-106
BACKWASH 7
FAST RINSE 3
TOTAL REGENERATION TIME _ 109.7-126.3
gpm = gallons per minute psi = pounds per square inch
gpg = grains per gallon ppm = parts per million
Does not include CLEAN feature cycle times if set to ON.
19