Gold's Gym trainer 550 User Manual page 10

9. While another person holds the Console Base
(26) near the right Handrail (18), attach the
ground wire on the Console Base to the right
Handrail with a #8 x 1/2" Ground Screw (11).
Connect the wire harness on the Console Base
(26) to the Upright Wire (28). See the inset
drawing. The connectors should slide to-
gether easily and snap into place. If they do
not, turn one connector and try again. IF THE
CONNECTORS ARE NOT CONNECTED PROP-
ERLY, THE CONSOLE MAY BE DAMAGED
WHEN THE POWER IS TURNED ON.
10. Insert the wires into the Console Base (26) as
you set the Console Base on the Handrails. Be
careful not to pinch the wires. Next, thread
two 1/4" x 1/2" Bolts (22) with 1/4" Star Washers
(21) into the Handrails and the Console Base;
do not tighten the Bolts yet.
Attach the Console Base (26) to the Handrails
(18) with four #8 x 3/4" Screws (2). Then,
tighten the two 1/4" x 1/2" Bolts (22).
11. Lower the Uprights (31, 36).
See the inset drawing. Position the Uprights
(31, 36) so that the Frame (74) is centered be-
tween the Uprights.
Firmly tighten the 3/8" x 3" Bolts (32) and then
the 3/8" x 2 1/4" Bolts (40) on each side of the
treadmill. Do not overtighten the 3/8" x 3"
Bolts.
9
Wire
Harness
28
10
Front View
26
18
21
2
22
11
74
View from Above
31
10
26
11 Ground
Wire
18
28
2
21
22
32
Side View
31, 36
74
18
40
36