IBM 7012 300 Series Installation And Service Manual page 122

Step 4. Setting Up the System Unit
1. Be sure the power cable on the system unit is unplugged and the power switch is set to
the Off position.
2. Remove the packing material from all of the media devices installed in the front panel.
3. Remove the rear cover and top cover.
4. Look at the memory cards, adapters, and internally installed drives to be sure they are
not loose and are in their proper positions.
5. Ensure that the cards are completely seated in the connectors by pushing down on
each card.
6. Fill out the "SCSI Device Address Record" in Appendix A of this book.
7. Ensure that the SCSI terminator is installed.
8. Install the top cover.
For instructions on the foot position, refer to "Changing the System Unit Base" in Chapter 7
of the 7012 300 Series Operator Guide .
Step 5. Set Up Each Device Being Attached
Note: During the setup of each device, connect only the device end of the signal cable. Do
Do the setup instructions provided in the documentation with each device being attached to
this system unit; then return to step 6 of these instructions.
4-4
Installation and Service Guide
not connect the device signal cables to the system unit now.