IBM 7012 300 Series Installation And Service Manual page 100

Models 380, 390, 39H, and 397
397 Planar
Rear Aligning Pin
Planar
(all models except
380, 390, 39H, and
397)
Card Guide
Screws
Replacement
1. Be sure to tell the customer that time and date need to be reset after system planar
replacement.
2. For all models except 380, 390, 39H, and 397, as you install the EMI ground strip, ensure
that the system planar aligning tab (under the mouse connector) is under the system
planar.
3. Install the stand-off screws on the parallel port.
39H Planar
Card
Guide
Frame
Screws
Front Aligning
Pin
EMI Ground Strip
(not on models
380, 390, 39H, and 397)
Planar (All
other models)
Planar Aligning
Pins
Ground Strap Screw
(On all models except 380, 390,
39H, and 397)
Two Additional Screws on SCSI Port,
Models 340, 34H, 350, 355, 360/36T,
365, 370/37T, and 375 only:
Removal and Replacement Procedures
7012 Base
(all models except 380,
390, 39H, and 397)
Stand-off Screws
on Parallel Port
3-41