Control Panel Features - Kenmore ELITE 796.292796 Use And Care Manual

I I
nir!_i
WARNING:
To reduce the risk of fire, electric shock, or injury to persons, read and follow this
entire Use & Care Guide, including the Important Safety Instructions, before operating this washer.
CONTROL PANEL FEATURES
POWER
Normal/Casual
Bulky/Beddlng
Stain Treat _GMSov_ _ Kids Wear
Fob,, ,o,tono, To e,s
Ex,ro_o,o_in_o_,o, ili Sook Colors
AddAG ..... t i DeleyWash _i HeovyDuty
Express Wash
Cold Clean
Sanitize
Dellcates
Handwash/Wool
Workout Wear
Extra Hob/Cold Extra High Heavy
Hot/Cold High
Warm/Warm Medium
W_rm/C01d Low o
Cold/Cold No Spin Light
START/PAUSE
O
POWER (ON/OFF) BUTTON
Press to turn the washer ON. Press again to turn the
washer OFF.
NOTE: If the washer remains idle for 4 minutes after
turning the washer off, any water left in the tub will
automatically be drained. An alarm will sound 1 minute
prior to draining, and 'dr' will appear on the display.
You may restart the washer at this time. However,
once the washer initiates draining, all functions will be
suspended, and 'dr' will be displayed until draining is
complete and all cycle settings will be lost.
g
CYCLE SELECTOR KNOB
Turn this knob to select the desired cycle. Once the
desired cycle has been selected, the standard presets
will be shown in the display. These settings can be
adjusted using the modifier and option buttons anytime
before starting the cycle. (See the cycle guide on page
14 for allowable settings. To protect your fabrics, not all
settings are allowed in all cycles.)
e START/PAUSE BUTTON
Press this button to start the selected cycle.
If the washer is running, use this button to pause the
cycle without losing the current settings.
NOTE: If you do not press the START/PAUSE button
within 4 minutes of selecting a cycle, the washer auto-
matically turns off.
NOTE: If the washer remains idle for 8 minutes after
pausing the cycle, the water in the tub will drain and all
lost. See page 22 for details.
e
g
o
CYCLE MODIFIER BUTTONS
Use these buttons to adjust the desired settings for the
selected cycle. The current setting will be lighted, and
pressing the button will cycle through the available
settings. See page 19 for a complete description.
NOTE • Not all settings are available on all cycle
selections. See chart on page 14 for details.
CYCLE OPTION BUTTONS
The option buttons allow you to select additional cycle
options and will light when selected. Certain buttons
also allow you to activate special functions by pressing
and holding the button for 3 seconds.
For detailed information about the individual options,
please see pages 20, 21, and 22.
TIME AND STATUS DISPLAY
The display shows the estimated time remaining and
cycle status.
See page 18 for a complete description.
12
I I