Installations; Using The Freezer - Bromic Heating 100 ltr. Operating Instructions Manual

OPERATING INSTRUCTIONS
Please read the instructions carefully before starting operation as get best results.
Contents:
1

Installations

2 Technical instructions
3 Control and indicating lights
4

Using the freezer

5 Defrosting
6 Maintenance
7 Trouble-Shooting
1-INSTALLATIONS
a- Never place the freezer directly in sunlight and close to heat-emitting sources such as radiators stoves etc.
b- Don't also place the freezer to an area suitable for suitable for air currents or winds.
c- Don't prevent air circulation around the compressor unit. For a better result in compressor's working conditions there must
be at least 10 cm. distance between the wall and the freezer.
d- If the freezer is transported when it is still cold, do not plug until the compressor reaches to +5C
e- Plug in earthed supply which will supply the voltage indicated rating plate.
f- Unplug the freezer if there is a temporary power failure. Wait for about 20 min. then plug in again. If the freezer's plug does
not fit in your plug-hole replace the freezer's plug. This replacement should be done by skilled person or service men.
2-TECHNICAL SPECIFICATIONS OF THE FREEZERS
a- Your freezer has double condenser system. This enables compressor work in a most efficient way and leads to better
cooling.
b- Freezers are insulated with 60 mm. thickness polyurethane insulation(coefficient of heat /0.020 K.cal/mhk).
This results to a best insulation.
3-CONTROLLING AND INDICATING LIGHTS
The internal temperature of the freezers is automatically adjusted by the thermostats. To decrease the temperature, turn the
thermostat knob clockwise. We advise you to fix the thermostat knob in the middle, if the ambient temperature is +20C or
25C.
Quick Freezer
If this button pressed, the thermostat will be off so the freezer will operate continuously. We again advise you to consider the
ambient temperature and the lid's opening frequency as to arrange the thermostat knob relatively.
Green Light: It shows when you plug in.
Red Light: It signals when the inside temperature closes to -10C or higher instead of -15C.(which is desired) and
shows that the freezer is not operating properly, on the other hand, when you put in fresh vegs and others the red light may
show. This caused only for temporary temperature rising so there is nothing to worry. If the light keeps on showing we advise
you to check the lid in case it is open if not, you better check the plug if it is properly plugged.
Orange Light: It is concerned with quick freezing and should be used in following situations.
a- When you first plug in your freezer and for 24 hours.
b- As to quick freeze before defrosting. In this case light must on 24 hours before putting anything.
c- We advise you to quick freeze before defrosting. At the end of quick freeze turn the quick freeze button off. Orange light will
disappear, which means the freezer now in frozen storing.
4-USING THE FREEZER
When you first plug in your freezer, turn the quick freeze button on. The orange light will show. Do not load freezer, keep the lid
closed. Then leave the freezer for 24 hours in this condition. Do not forget turn the quick freeze button off. Don't change the
thermostat setting, prepare and pack the food then place them in the freezer. Do not exceed freezing capacity in 24 hours when
you load fresh goods each time.