Related Manuals for Bromic Heating 3735203-NR
Summary of Contents for Bromic Heating 3735203-NR
- Page 1 UPRIGHT STORAGE CHILLERS AND FREEZERS 3735203-NR, 3735161-NR, 3735200-NR, 3735194-NR 01/2022 - V7...
-
Page 2: Table Of Contents
CONTENTS 1. PREFIX 2. IMPORTANT NOTES & WARNINGS 3. PRODUCT OVERVIEW 4. INSTALLATION 5. OPERATION 6. PRODUCT LOADING AND STORAGE 7. MAINTENANCE 8. TROUBLESHOOTING 9. ENVIRONMENTAL & DISPOSAL NOTES 10. WARRANTY Note: Bromic Refrigeration reserves the right to make changes to specifications, parts, components and equipment without prior notification. This Installation, operation and service manual may not be reproduced in any form with prior written consent from Bromic Refrigeration. -
Page 3: Prefix
1. PREFIX This manual contains important information about the installation, operation, and maintenance of Bromic upright storage chillers and freezers. Please pay close attention to the important safety information shown throughout this instruction manual. Any safety information will be accompanied by the following safety alert symbols: DANGER, WARNING, IMPORTANT... -
Page 4: Important Notes & Warnings
2. IMPORTANT NOTES AND WARNINGS • Read all instructions before installing or using this appliance. • Retain this manual for future reference. • Use this appliance only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury. - Page 5 Warning: Risk of fire / Flammable materials • The refrigerant used in this appliance is flammable, use caution during handling, servicing and disposal of the appliance. • Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance. •...
-
Page 6: Product Overview
3. PRODUCT OVERVIEW UC0650SD UF0650SDF UC1300SD UF1300SDF Part Number 3735161-NR 3735203-NR 3735200-NR 3735194-NR Height, mm 2010 2010 2010 2010 External Dimension Width, mm 1480 1480 Depth, mm Net Capacity Litres 1035 1035 Net Weight Air Circulation Type Forced Forced Forced... -
Page 7: Installation
4. INSTALLATION Locating the Cabinet Ensure the following instructions are observed as this is vital for proper and trouble-free operation. • Do not install the cabinet outdoors. • Locate the appliance in a dry and well ventilated place. • The unit must be positioned on a level surface. •... - Page 8 Power Supply • The appliance must not be plugged into a multiple outlet power board. • The appliance is supplied with a flexible power cord fitted with a 3-pin plug. • The socket used must be properly earthed and fuse/RCD protected. •...
-
Page 9: Operation
5. OPERATION Start-up • Connect the appliance to the mains power supply and turn on the main switch by flipping it upward. • The compressor and condenser fan should operate within 3 minutes after the main switch is turned on. •... -
Page 10: Product Loading And Storage
6. PRODUCT LOADING AND STORAGE IMPORTANT: Run the refrigerator for at least 2 hours before loading. WARNING: WARNING: Do not store explosive substances such as aerosol cans with a flammable propellant inside the appliance. Start-up • Clean the interior surface with a soft cloth and warm water before loading. •... -
Page 11: Troubleshooting
Cleaning the Cabinet • Remove the products and transfer to a suitable location prior to cleaning the inside of the cabinet. • Do not use any aggressive or abrasive cleaning agents. • Never use a water hose or a high-pressure jet to clean. •... -
Page 12: Environmental & Disposal Notes
9. ENVIRONMENTAL AND DISPOSAL NOTES These refrigerated cabinets are designed to high standards of environmental protection and recycling convenience. Cyclopentane, an environmentally friendly foaming agent, has been used. Cyclopentane is distinguished by zero ozone depletion potential (ODP) and zero global warming potential (GWP). The refrigerant used and contained within a hermetically tight circuit is environmentally friendly and does not contain chlorine and zero ODP. - Page 13 HOW TO PLACE A SERVICE REQUEST • Please call 1300 276 642 to place a warranty service request and let the operator know whether you need Priority A or B service. More information can be found below. • Ensure you have the serial number of your product ready before contacting us. •...
- Page 14 SYDNEY HEAD OFFICE & SHOWROOM 10 Phiney Place, Ingleburn NSW 2565 Australia T: AU 1300 276 642 F: (+61) 1300 735 115 E: refrigeration@bromic.com NSW VIC QLD TAS WA SA NT ACT BROMICREFRIGERATION.COM.AU...