Switch Assembly, Paper Detector - Digital Equipment LG plus Series Maintenance Manual

Switch Assembly, Paper Detector

Removal
1. Prepare the printer for maintenance (page 4–2).
2. Remove the paper path (page 5–29).
3. Loosen four screws and remove the barrier shield. (See page 5–59,
Figure 5–10, items 3, 4, and 9.)
4. Remove the two 1/4 inch screws securing the paper detector switch
assembly. (See Figure 5–15, page 5–69.)
5. Trace the paper detector switch cable back to the controller board,
releasing the cable from the restraints under the base casting. (See cable
routing diagram on page A–10.)
6. Disconnect connector shell P106 from the controller board.
7. Trace the paper detector switch wires to the connector shell, and remove
the cable connector from the connector shell (page 5–8).
8. Remove the paper detector switch assembly.
5–46 Replacement Procedures and
Illustrated Parts List