Table of Contents
Advertisement
Connecting an antenna or cable TV (no box)
On your TV
Coaxial cable
connector
ANT/CABLE IN
jack
1 Make sure that your TV's power cord is unplugged and all connected equipment is turned off.
2 Connect a coaxial cable (not provided) to the ANT/CABLE IN jack on the side of your TV and to the antenna or
cable TV wall jack.
3 Plug your TV's power cord into a power outlet, then turn on your TV.
4 Press INPUT to open the INPUT SOURCE list.
5 Press
or
to highlight TV, then press ENTER.
6 If you cannot tune to channels you know exist, scan for channels. See "Automatically scanning for channels" on
page 56.
Notes
• Use a coaxial cable to eliminate interference and noise from radio
• Do not bundle the coaxial cable with the power cord or other cables.
• If the antenna is not installed correctly, contact qualified service
• If the signal level for a channel is weak, the picture may be distorted.
• If the picture quality is good on some channels and poor on others, the
• If you connect to cable TV without a set-top box and experience poor
• Many high-definition (HD) channels upscale standard-definition (SD)
Antenna or cable TV
(no box)
waves.
personnel to correct the problem.
Adjust the antenna or use a highly directional outdoor or set-top
antenna with a built-in amplifier.
problem may be caused by a poor or weak signal from the broadcaster
or cable TV provider.
picture quality, you may need to install a set-top box to improve signal
reception and picture quality. Contact your cable TV provider about
upgrading to a set-top box.
content. The picture displayed on your TV is still displayed as SD, thus
the picture quality will not be as clear or crisp as it would be if the
content was originally recorded in HD.
www.insigniaproducts.com
Side of TV
Coaxial cable
NS-50D550MX15 Insignia 50" LED TV
22
Advertisement
Table of Contents
