Connect The Scanner To The Computer - Polaroid SprintScan 4000 Installer Quick Start Manual

4 Connect the Scanner to
the Computer
The SprintScan 4000 requires a SCSI host adapter in your com-
puter. If your computer does not have an adapter, you must install
one (see page 14). If your computer is a PC-compatible with a
SCSI adapter, but the adapter is connected to a hard drive or CD-
ROM drive, installing a second adapter is recommended.
Set the scanner SCSI address:
Each device connected to a SCSI host adapter must have a unique
address from 0-6. To assure a unique address for the scanner,
determine the addresses of any other SCSI devices.
Power Mac or Power PC
Run Apple System Profiler
1
program, usually on the
Apple menu. If not, it may
be available from
www.apple.com/swupdates.
Click Devices and Volumes
2
to view the SCSI device
addresses.
Windows 95, 98 or NT
Look at the address switch
on each SCSI device con-
nected to your system. If
necessary, see instructions
provided with the devices.
Make sure the scanner is turned off and set the address switch to a
value not used by any other device.
SCSI
address
switch
Do not use 7, 8 or 9
(not valid addresses)
The address is preset to 6. Do not change it unless another
Note:
device is using 6. Other addresses typically available are 2, 4, and 5.
English 7