Attaching The Dash Buckets - Precor PRECISION SERIES Quick Start Card

Attaching the Dash Buckets

Note: The fasteners used to secure the dash buckets to the console bracket also
secure the console to the bracket.
The dash buckets fit on either side just behind the console. To position them, tilt
them so that the bottom side rests on the handrail and the side tab is positioned
behind the console and bracket.
Figure 14: Position of dash buckets on dash and handrail assembly
Attaching the Console to the Treadmill
Important: To ensure proper assembly, perform the following steps in the order
presented.
To attach the dash buckets:
1. Position the right dash bucket so that the mounting holes line up with the
console bracket holes and the welded bracket on the handrail assembly.
Figure 15: Slide the dash bucket behind the console
2. Secure the dash bucket to the console bracket using two ¹ ₄-inch x ¹ ₂-inch
buttonhead screws. Fully tighten the screws.
Note: If the lower screw does not engage, remove the console and make sure
that no cables are being pinched between the console and the console
bracket.
Figure 16: Dash bucket and console attachment
11