Remote Panic Operation; Trunk Release/Optional Device Channels - Prestige APS-25E Owner's Manual

3 button remote security system
Hide thumbs Also See for APS-25E:
Table of Contents

Advertisement

2. Within 10 seconds of turning the ignition key off, press and release the LED valet
push-button switch three times.
3a. If, before proceeding with step 2, the chirps were on, then you will hear 2 chirps
to indicate that the chirps have been turned off.
3b. If, before proceeding with step 2, the chirps were off, then you will hear 1 chirp
to indicate that the chirps have been turned on.
NOTE:
Whenever the chirps are by-passed, the 3 chirp defect and 4 chirp in-
trusion indicator will always operate. This feature will always warn you if
there is a defective sensor during the arming sequence or if the vehicle
had been tampered with in your absence, even if the normal arming and
disarming chirps have been turn off.

REMOTE PANIC OPERATION:

The Lock and Unlock buttons on your keychain transmitter also functions as a
"panic" switch for instant activation of the alarm in emergency situations. To use
the remote panic switch;
1. Press and hold the arming button on the keychain transmitter for 3 seconds or
more. The alarm will immediately sound.
2. To stop the alarm, press and release the Trunk/Key button on the keychain
transmitter. If the button is not pressed, the alarm will automatically stop after
30 seconds.
TRUNK RELEASE:
This security system has an additional feature that can be wired to a number of dif-
ferent optional accessories. Some of the more common uses for this "channel" are:
 Remote Trunk Release - available for any vehicle with factory installed electronic
push-button trunk release.
 Remote Car Starter - available for most automatic transmission, fuel injected
vehicles.
 Remote Window Roll Up - available for most vehicles equipped with power
windows.
TO ACTIVATE THIS OPTIONAL ACCESSORY
Press and hold the Trunk/Key button on the keychain transmitter for approximately 3
seconds. If the system has been programmed differently by your installation center,
this output may be accessed by pressing buttons 1&2 simultaneously for 3 seconds.
NOTE: This feature will not operate when the vehicle's ignition key is turned "ON".
Page 6
128-9321
Page 6/8

Advertisement

Table of Contents
loading

Table of Contents