Download Print this page

Prestige 1286469 Installation Manual

Advertisement

Quick Links

RF Programmable Features :
Feature Selection
1st Door L/UL
2nd Accy Lock
3rd Accy. UL
4th Non Functional
5th Passive Locks
6th Passive/Active Arm
7th Voltage Sense
8th Siren/Horn
9th Horn Chirp
10th Override Method
11th Two Step Unlock
12th Chirp Delete From Tx
To program these selectable features;
Action
Turn ignition on
Press and release the valet switch 3 times
Within 3 seconds, turn ignition Off
First
Then On
Press transmitter Lock button to change
Press transmitter Lock button to change
Second
Press and release the valet switch
Press transmitter Lock button to change
Third
Press and release the valet switch
Press transmitter Lock button to change
Press transmitter Lock button to change
Fourth
Press and release the valet switch
Fifth
Press and release the valet switch
Press transmitter Lock button to change
Sixth
Press and release the valet switch
Press transmitter Lock button to change
1 Chirp
2 Chirps
1 Sec.
3.5 Sec.
Auto Lock On
Auto Lock Off
Auto UL Dr
Auto UL All
Passive
Active
Passive Arm
Active Arm
Voltage Sense
Hardwire
Siren/Horn
Siren Only
10mS
16mS
Custom Code
Valet
On
Off
On
Off
or
or
or
or
or
or
Model APS-410a
Installation Manual
3 Chirps
4 Chirps
1 Sec L, Dbl. U/L
Auto UL Off
Horn Only
30mS
System Response
No response
1 Chirp - LED 1 flash
Short chirp, then long chirp
1 chirp = 1 second door locks
2 chirps = 3.5 second door locks
3 chirps = 1 sec. lock, dbl 1 sec. unlock
2 chirps = auto locks off
1 chirp = auto locks on
3 chirps = auto unlock off
1 chirp = auto unlock drivers door only
2 chirps = auto unlock all doors
Non Functional
2 chirps = active locks
1 chirp = passive locks
2 chirps = active arming
1 chirp = passive arming
Default
1 Sec.
Auto Lock Off
Auto UL Off
NA
Active
Active Arm
Hardwire
Siren/Horn
16mS
Valet
Off
Off
128-6469
1 of 8

Advertisement

loading
Need help?

Need help?

Do you have a question about the 1286469 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Prestige 1286469

  • Page 1 Model APS-410a Installation Manual RF Programmable Features : Feature Selection 1 Chirp 2 Chirps 3 Chirps 4 Chirps Default 1st Door L/UL 1 Sec. 3.5 Sec. 1 Sec L, Dbl. U/L 1 Sec. 2nd Accy Lock Auto Lock On Auto Lock Off Auto Lock Off 3rd Accy.
  • Page 2 Seventh Press and release the valet switch 2 chirps = hardwire Press transmitter Lock button to change 1 chirp = voltage sense Eighth Press and release the valet switch 1 chirp = siren and horn output Press transmitter Lock button to change 2 chirps = siren output only Press transmitter lock button to change 3 chirps = horn output only...
  • Page 3: Wiring The System

    vehicle. Avoid areas near high heat components or moving parts within the engine compartment. To prevent water retention, the open end of the siren must be pointed downward when mounted. Mount the siren to the selected location using the screws and bracket provided. Hood or Trunk Pin Switch: A pin switch is included for use in protecting the hood or trunk ( or hatchback ) of the vehicle.
  • Page 4 Note: This is a normally closed starter cut arrangement, and when power is removed from the security system, the starter disable feature will not operate, allowing the vehicle to start. Audiovox does not recommend using the Orange wire to interrupt anything but the starting circuit of the vehicle.
  • Page 5 Note: This is a normally opened starter cut arrangement and when power is removed from the security system, the starter disable feature will remain operational, and the vehicle will not start. Audiovox does not recommend using the Orange w/ White trace wire to interrupt anything but the starting circuit of the vehicle.
  • Page 6 the green wire to the wire that provides a low current ground signal from the factory door unlock switch to the factory door unlock control relay. Red/Black Not Used. 3 Wire Ground Switched 2 Step Door Locks In this application, the red wire provides a ground pulse during arming, or the pulsed ground lock output. Connect the red wire to the wire that provides a low current ground signal from the factory door lock switch to the factory door lock control relay.
  • Page 7: Completing The Installation

    These applications require the use of additional components which may include relays, fixed resistors, or for convenience, the AS 9159 Door Lock Interface. Refer to the AUDIOVOX Door Lock Wiring Supplement and or the Audiovox fax back service for information on your particular vehicle for properly connecting to these types of circuits.
  • Page 8 © 2003 Audiovox Electronic Corporation, 150 Marcus Blvd., Hauppauge, N.Y. 11788 128-6469 128-6469 8 of 8...

This manual is also suitable for:

Platinum+ aps-410a