Download Print this page

Advertisement

Available languages

Available languages

Quick Links

Note : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver's door pin
switch in order to begin the passive arming sequence.
RF Programmable Features :
Feature Selection
1st Door L/UL
2nd Accy Lock
3rd Accy. UL
4th Passive Locks
5th Passive/Active Arm
6th Voltage Sense
7th Siren/Horn
8th Horn Chirp
9th Override Method
10th Two Step Unlock
11th Chirp Delete From Tx On
To program these selectable features;
Turn ignition on No response
Press and release the valet switch 3 times
Within 3 seconds, turn ignition Off
First
Then On
Press transmitter Lock button to change
Press transmitter Lock button to change
Second
Press and release the valet switch
Press transmitter Lock button to change
Third
Press and release the valet switch
Press transmitter Lock button to change
Press transmitter Lock button to change
Fourth
Press and release the valet switch
Press transmitter Lock button to change
Fifth
Press and release the valet switch
Press transmitter Lock button to change
Sixth
Press and release the valet switch
Press transmitter Lock button to change
Seventh
Press and release the valet switch
Press transmitter Lock button to change
Press transmitter lock button to change
SELECTABLE FEATURES
1 Chirp
2 Chirps
1 Sec.
3.5 Sec.
Auto Lock On
Auto Lock Off
Auto UL Dr.
Auto UL All
Passive
Active
Passive Arm
Active Arm
Voltage Sense Hardwire
Siren/Horn
Siren Only
10mS
16mS
Custom Code
Valet
On
Off
Off
Action
or
or
o r
o r
o r
o r
Model APS-255CH
Installation Manual
3 Chirps
4 Chirps
1 Sec L, Dbl. U/L
Auto UL Off
Horn Only
30mS
System Response
1 Chirp - LED 1 flash
Short chirp, then long chirp
1 chirp = 1 second door locks
2 chirps = 3.5 second door locks
3 chirps = 1 sec. lock, dbl 1 sec. unlock
2 chirps = auto locks off
1 chirp = auto locks on
3 chirps = auto unlock off
1 chirp = auto unlock dr.
2 chirps = auto unlock all
2 chirps = active locks
1 chirp = passive locks
2 chirps = active arming
1 chirp = passive arming
2 chirps = hardwire
1 chirp = voltage sense
1 chirp = siren and horn output
2 chirps = siren output only
3 chirps = horn output only
Default
1 Sec.
Auto Lock Off
Auto UL Off
Active
Active Arm
Hardwire
Siren/Horn
16mS
Valet
Off
Off
128-6458
1 of 16

Advertisement

loading
Need help?

Need help?

Do you have a question about the 1286458 and is the answer not in the manual?

Questions and answers

Summary of Contents for Prestige 1286458

  • Page 1 Model APS-255CH Installation Manual SELECTABLE FEATURES Note : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver’s door pin switch in order to begin the passive arming sequence. RF Programmable Features : Feature Selection 1 Chirp 2 Chirps 3 Chirps 4 Chirps...
  • Page 2 Eight Press and release the valet switch 2 chirps = horn chirp output 16mS Press transmitter Lock button to change 3 chirps = horn chirp output 30mS Press transmitter Lock button to change 1 chirp = horn chirp output 10 mS Ninth Press and release the valet switch 2 chirps = valet switch override operation...
  • Page 3: Wiring The System

    Shock Sensor : Select a solid mounting surface for the shock sensor on the firewall inside the passenger compartment and mount the sensor using the two screws provided. The shock sensor can also be secured to any fixed brace behind the dash using tie straps. Whichever mounting method is selected, make certain that the sensitivity adjustment is accessible for use later in the installation.
  • Page 4 Note : This is a normally closed starter cut arrangement and when power is removed from the security system, the starter disable feature will not operate, allowing the vehicle to start. Audiovox does not recommend using the Orange wire to interrupt anything but the starting circuit of the vehicle.
  • Page 5 Red / Green / Red w/Black Trace 3 Pin White Connector : Door Lock Outputs The Red and Green wires will provide either a pulsed ground output to the factory door lock control relay, or a pulsed + 12 volt output to the factory door lock control relay. In either case, the maximum current draw through these outputs must not exceed 300 mA.
  • Page 6: Completing The Installation

    These applications require the use of additional components which may include relays, fixed resistors, or for convenience, the AS 9159 Door Lock Interface. Refer to the AUDIOVOX Door Lock Wiring Supplement and or the Audiovox fax back service for information on your particular vehicle for properly connecting to these types of circuits.
  • Page 7 © Audiovox Electronic Corp. 150 Marcus Blvd., Hauppauge, N.Y. 11788 128-6458 128-6458 7 of 16...
  • Page 8 Model APS-255 Manuel D'Installation SÉLECTION DES FONCTIONS Remarque: Lorsqu’on choisit à la fois l’armement passif et la détection de tension, il faut que le contacteur de la porte du conducteur soit compris dans le circuit de montage pour que la séquence d’armement passif puisse commencer. Fonctions programmables sur les canaux de radiofréquence: Fonction Une tonalité...
  • Page 9 Action Réponse du système Réponse du LED Dixième Appuyez sur et libérez le commutateur de valet une fois 1 Tonalité = Déverrouillage la porte d'opérateurs 10 clignotements Appuyer sur le bouton 1 du transmetteur pour changer d'abord, puis toutes les portes 2 Tonalités = Toutes les portes déverrouillage Onzième Appuyez sur et libérez le commutateur de valet une fois...
  • Page 10 DÉTECTEUR DE TENSION: Choisir une surface de montage pleine pour le détecteur de tension, sur la paroi coupe-feu, à l’intérieur du compartiment passager, et monter le détecteur de tension à l’aide des deux vis fournies avec l’appareil. Le détecteur de tension peut aussi être fixé à toute patte de fixation située derrière le tableau de bord, à l’aide d’attaches. Quelle que soit la méthode de montage choisie, il faut s’assurer que le réglage de sensibilité...
  • Page 11 Remarque: Il s’agit d’un aménagement de coupure de circuit de démarreur normalement fermé et lorsque le système de sécurité est hors tension, la fonction de désactivation du démarreur est inopérante, permettant au véhicule de démarrer. Audiovox ne recommande l’usage du fil orange que pour la coupure du circuit de démarreur du véhicule et rien d’autre.
  • Page 12 relais de commande de serrure de la porte du véhicule. Dans l'un ou l'autre cas, le courant de maximum de ces sorties ne doit pas excéder 300 mA. Le rouge - le fil noir fournit une impulsion du négatif 300 mA quand le bouton pour ouvrir l'émetteur est actionné...
  • Page 13 THIS PAGE LEFT BLANK INTENTIONALLY 128-6458 13 of 16...
  • Page 14: Finition De L'installation

    Dans ces application, il faut utiliser l'interface de verrouillage de porte AS-9159 (ou un relais automobile équivalent de 30A). Se reporter au supplément de câblage de verrouillage de porte AUDIOVOX, pour effectuer convenablement le raccordement de ces types de circuit.
  • Page 15 128-6458 15 of 16...
  • Page 16 © Audiovox Electronic Corp. 150 Marcus Blvd., Hauppauge, N.Y. 11788 128-6458 128-6458 16 of 16...

This manual is also suitable for:

Platinum aps-255ch