Arming The System - Prestige APS-25E Owner's Manual

ARMING THE SYSTEM: (ACTIVE)
1. Turn off the engine, exit the vehicle, and close and lock all doors, hood and
trunk.
2. Press and release the Lock button on the keychain transmitter. The siren
will "chirp" once, the vehicle's parking lights will flash once, the doors will
lock (optional) and the dash mounted LED will begin to slowly flash.
WARNING! Excessive pressure on the transmitter buttons will damage the in-
ternal components on the circuit board. All that is required is a light
push to the button.
NOTE: If the siren "chirped" three times when Locked, then one of the entry points
(hood, trunk, doors) has been left opened. Closing the hood, trunk, or doors
will correct the problem and you do not need to disarm the system to make
the correction. If the siren "chirped" three times, sometime after arming,
the exclusive delayed dome light learn circuit has been programmed and
the system detected a open entry point after the learned delay expired.
Again, closing the hood, trunk, or doors will correct the problem and you
do not need to disarm the system to make the correction.
ARMING THE SYSTEM: (PASSIVE)
1. Turn off the engine, exit the vehicle, close and lock all doors, hood and trunk.
2. The dash mounted LED will begin to flash rapidly, indicating that the system
is automatically (passive) arming. As an added convenience, the automatic
passive arming will not begin until all doors and trunk lid are closed, allowing
passengers to exit the vehicle at their convenience.
3. In 30 seconds, you will hear a single short "chirp" from the siren and the
vehicle's parking lamps will flash one time, indicating the system is ARMED.
At this time, the dash mounted LED will begin to flash slowly, providing a visual
indication that the system is fully ARMED.
OPTION NOTE: If the optional (not included) power door lock interface has been
installed, the alarm control module can be programmed to:
a) Automatically lock the doors during step 3 above, or
b) Lock the doors only when the transmitter is operated
4. If you wish to arm the system immediately, simply press and release the
ARMING button on the keychain transmitter. The siren will "chirp" once, the
vehicle's parking lamps will flash once, the doors will lock (optional), and the
dash mounted LED will begin to slowly flash.
Page 3
128-9321
Page 3/8