Belt Changing And Agitator Cleaning; Light Bulb Changing - Kenmore 116.28614 Owner's Manual

TO REPLACE BELT
!. install new
belt over
motor drive,
then over
belt path°
NOTE: See
PARTS AND
FEATURES
for Belt hum-
hero
Agitator End Cap
Motor
Drive
Path
2, Place agitator
assembly back into
PowerMate.
3. Line up
front of
cover and
base, Rest
cover on
front edge
of base as
shown.
Side
Latch
Cover Base
4, Rotate cover
i {_- back,, Press
_._ cover firmly until
_ side and rear
latches snap
Rear
into place,
Latches
Make sure there is no gap between the
cover and base°
5. Turn PowerMate upside down and
replace two (2) cover screws,
I
LIGHT BULB CHANGING
1. Remove PowerMate cover as shown in
BELT CHANGING AND AGITATOR
CLEANING section,
2. Push in and turn
bulb counterclock-
wise, then pull out
to remove,,
--'-'_Push in
l! 3. Push in and turn
And
Turn L-_ bulb clockwise, to
._,/-&,_'_:___ replace, Bulb must
not be higher than
15 Watts( 130 Volts)°
4. Reinstall PowerMate cover as shown in
BELT CHANGING AND AGITATOR
CLEANING section,
NOTE: See PARTS AND FEATURES for
bulb number,,
1
18