Belt Changing And Agitator Cleaning - Kenmore 116.23103C Owner's Manual

PIÈCES ET CARACTÉRISTIQUES
Il est important de connaître les pièces et les caractéristiques de l'aspirateur pour l'utiliser correctement et en
toute sécurité. Lire cette section avant de l'utiliser.
Pièce Nº aux Nº Au
Etats-Unis Canada
Ampoule 20-5240 20-40600
Courroie 20-5285 20-40110
PowerMate ®
Porte-cordon
Courroie
Numéros de
modèle/série
PowerMate ®
(Au bas)
Porte-
cordon
Pédale de
relâchement de manche
Pédale de
hauteur de poils
Porte-fiche
Relâche
rapide de
la poignée
Porte-cordon
Tube
Tube
supérieur
supérieur
Cordon électrique
PowerMate ®
Éclairage
Couvercle de lampe
Indicateur de
hauteur de poils
Nettoyeur
de bords
(Non illustré)
Protecteur de surcharge
(Bouton de remise en circuit)
4

BELT CHANGING AND AGITATOR CLEANING

TO REMOVE BELT
1. Remove light cover
and light bulb as shown
under LIGHT BULB
CHANGING.
2. Unscrew the
PowerMate ® cover
screws.
3. Turn
PowerMate ®
To remove cover,
insert screwdriver
between nozzle
cover tab and the
base. Pry up to
release tabs.
4. Turn
PowerMate ®
right side up.
Press handle
release pedal
and lower the
swivel. Rotate
cover forward
from back until
front snaps free.
5. Carefully
insert and lift
screwdriver at
End
each end cap
Base
Cap
to free agitator
Base
assembly from
base.
6. Remove worn belt.
7. Check and clean end cap areas. See
AGITATOR ASSEMBLY for picture of
complete agitator assembly.
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacuum
cleaner, the agitator must be cleaned every
time the belt is changed.
The agitator must also be cleaned according
to the following schedule:
Vacuum Cleaner Use Clean Agitator
HEAVY - every week
(used daily)
MODERATE - every month
(used 2-3 times/week)
over.
LIGHT - every 2 months
(used 1 time/week)
IMPORTANT
Turn off and unplug vacuum cleaner from
electrical outlet. Check and remove hair,
string and lint build-up frequently in the
®
PowerMate agitator and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator or end caps.
AGITATOR ASSEMBLY
Brush
Unit
End Cap
17
Belt
Pulley
End Cap