Bosch BSS250E-2 Installation And User Manual page 27

Maximum Inlet Water Pressure (Booster)
Input voltage single phase 50Hz
Maximum output current
Inlet gas connection male thread
Cold water connection male thread
Hot water connection male thread
Relief valve pressure setting
DATA PLATE
Fitted inside of front cover
GAS TYPE
The gas type is nominated on a temporary label located on the front cover, and on the data
plate located inside the front cover. The gas type is the gas on which this appliance is
designed to operate.
WARNING LABELS
Located on the front of the cabinet- PLEASE READ THESE LABELS CAREFULLY!
POSITION FOR INSTALLATION
The heater must be installed by using a fixing method sufficient to hold the 20Kg weight of unit
(see the technical sheet for dimensions of mounting brackets and positions)
N.B.: On combustible surfaces e.g. weatherboards etc. it is not required to install a fire proof
back board.
APPLIANCE LOCATION
(1) This Gas solar water heater is approved for outdoor installation only.
(2) Do not install this water heater with any modification or alteration.
(3) Do not install this water heater indoors or in an enclosed space .
WARNING:
FLUE OUTLET MUST BE FREE FROM ANY COMBUSTIBLE MATERIAL.
DO NOT OPERATE WITH ANY OTHER GAS TYPE.
1000 kPa
240 Volt
1 Amp
18mm
18mm
18mm
1600 kPa
27