Getting Readyto Sew; Connecting Machine To Power Supply; Before Using Your Sewing Machine; For Your Safety - Kenmore 385.19005 Owner's Manual

SECTION ii. GETTING READY TO SEW
Connecting Machine to Power Supply
l_ Power supply plug
(2"_) Power switch
(._ Outlet
(_) Foot control
_1 Foot controi plug
('_)Machine plug
(_) Mach ne sockets
t .. Turn off the power switch (_). Insert the foot control ptug
_._and machine plug (_ into the machine sockets _")
2. Insert the power supply plug CI into the outlet (_._
3.. Turn the power switch (_) to turn on the power and
the sewing light.
Note: ...............
• If you turn off the power switch, wait 5 seconds before
turning it on again
Before Using '/'our Sewing Machine
Before using your sewing machine for the first time, place a
waste fabdc under- the presser foot and run the machine
with thread for a few minutes_ Wipe away any oil which may
appear,.
For Your Safety
* While in operation, always keep your eyes on the sewing
area. Do not touch any moving parts such as the thread
take-up lever, handwhee! or needle
* Always turn off the power switch and unplug from the
power supply:
,, When leaving the machine unattended,
o When attaching or removing any parts,,
o When cleaning the machine,
* Do not place anything on the foot control, when not
sewing
Polarized Plug
This appliance has a polarized plug (one blade wider than
the other),, To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way If the plug
does not fit in the outlet, reverse the plug, if it still does not
fit, contact a qualified electrician to install the proper outlet,
Do not modify the plug in any way
\
0