Wind The Bobbin - Kenmore 385.15358 Service Manual

SEWING MACHINE DtV. 20 MODEL 384. 15358
WIND THE BOBBIN
1. PULL THE HANDWHEEL OUT.
2. DRAW THREAD FROM THE SPOOL. GUIDE THE THREAD AROUND THE THREAD
GUIDE. THREAD THROUGH THE BOBBIN WINDER TENSION DISK "A" AND THE
HOLE IN THE BOBBIN FROM THE INSIDE TO THE OUTSIDE.
3. PLACE BOBBIN ONTO BOBBIN WINDING SPINDLE "B" WITH END OF THREAD
COMING FROM THE TOP OF THE BOBBIN.
PUSH BOBBIN WINDING SPINDLE TO THE RIGHT UNTIL IT CLICKS.
4. HOLDING THE END OF THREAD, START MACHINE. WHEN BOBBIN IS SLIGHTLY
FILLED, SNIP OFF THE END OF THREAD.
5. WIND THREAD UNTIL BOBBIN STOPS. REMOVE BOBBIN.
6. PUSH THE HANDWHEEL TO THE LEFT.
B
PLACE BOBBIN IN BOBBIN CASE
MAKING SURE THREAD FEEDS
CLOCKWISE AND IS COMING
FROM BOBBIN AS SHOWN.
2 PULL THREAD THROUGH
SLIT OF CASE AS SHOWN.
HOLDING LATCH OPEN, POSITION 5
CASEINTO SHUTTLE AND
RELEASE LATCH.
CASE SHOULD LOCKINTO PLACE
WHEN LATCHIS RELEASED.
PULL THREAD UNDER TENSION
SPRING AND THROUGH THE
OPENING AS SHOWN ABOVE.