To Replace Needle Threader Plate - Kenmore 385.15358 Service Manual

SEWING MACHINE D tV.20 MODEL 3 84.15358
MECHANICAL ADJUSTMENT
TO REPLACE NEEDLE THREADER PLATE
TO REMOVE
1. REMOVE THE FOOT HOLDER.
2. PULL OUT THE THREADER PLATE UNIT (A).
TO ATTACH
3. PUSH THE THREADER PLATE UNIT (A) UP TO SNAP IT WITH THE PIN (B) AS SHOWN
IN FIG.1.
4. ATTACH THE FOOT HOLDER.
TO ADJUST THE POSITION OF THE THREADER PLATE (C)
IF THE THREADER PLATE IS SLIGHLY OUT OF ALIGNMENT, LOOSEN THE SETSCREW
(D) AND ADJUST THE POSITION AS SHOWN IN FIG.2.
IF THE ABOVE WAY OF ADJUSTMENT IS NOT APPLICABLE, MAKE THE ADJUSTMENT AS
SHOWN IN FIG. 3 AS FOLLOWS:
1. OPEN THE FACE PLATE.
2. WHEN THE THREADER PLATE IS:
TOO HIGH, LOOSEN THE HAXAGONAL SOCKET SCREW (E) AND LOWER THE
SETTING PLATE (F).
TOO LOW, LOOSEN THE HEXAGONAL SOCKET SCREW (E) AND RAISE THE
SETTING PLATE (F).
3. TIGHTEN THE HEXAGONAL SOCKET SCREW (E).
(FIG.l) (FIG. 3)
PIN (B)
HREADER PLATE UNIT (A)
SETTING PLATE (F)J
(FIG. 2)
THREADER PLATE (C) /
J
(x) ViEW
(x)
SETSCREW (D)
HEXAGONAL
SOCKET SCREW (E)
BAR
27