To Replace Needle Threader Plate - Kenmore 385.15218400 Service Manual

SEWING MACHINE DIV.20 MODEL 385.15218400
MECHANICAL ADJUSTMENT
TO REPLACE NEEDLE THREADER PLATE
TO REMOVE
1. REMOVE THE FOOT HOLDER.
2. PULL OUT THE THREADER PLATE UNIT (A).
TO ATTACH
3. PUSH THE THREADER PLATE UNIT (A) UP TO SNAP IT WITH THE PIN (B) AS SHOWN
IN FIG.1.
4. ATTACH THE FOOT HOLDER.
TO ADJUST THE POSITION OF THE THREADER PLATE (C)
IF THE THREADER PLATE IS SLIGHLY OUT OF ALIGNMENT, LOOSEN THE SETSCREW
(D) AND ADJUST THE POSITION AS SHOWN IN FIG. 2.
IF THE ABOVE WAY OF ADJUTMENT IS NOT APPLICABLE, MAKE THE ADJUSTMENT AS
SHOWN IN FIG. 3 AS FOLLOWS:
1. OPEN THE FACE PLATE.
2. WHEN THE THREADER PLATE IS:
TOO HIGH, LOOSEN THE HAXAGONAL SOCKET SCREW (E) AND LOWER THE
POSITIONING PLATE (F).
TOO LOW, LOOSEN THE HEXAGONAL SOCKET SCREW (E) AND RAISE THE
POSITIONING PLATE (F).
3. TIGHTEN THE SETSCREW (G).
II
(FIG, 1) II (FIG,3)
C_(_ PIN (B)
_ADER SETTING PLA TE_
PLATE UNIT (A)
(F)
(FIG.2)
TNREADER PLATE (C) I__; _I
(x)
\
\
(X) VIEW SETSCREW (D)
HEXAGONAL
SOCKET SCREW
27