Set Up The Machine ......................... 5; Free Arm Sewing; Change The Presser Foot; Choose The Needle And Thread - Kenmore 385.11607 Owner's Manual

SECTION 2. PREPARE THE MACHINE FOR SEWING
Set Up the Machine (Continued)
• Free-Arm Sewing: the Removable
Extension Table
\
\
\
\
• Accessory Storage Box
-_ f f
To Remove the Extension Table
(for free-arm sewing)
1. Grip the table with your index finger
and thumb, as shown.
2. Pull gently to the left. The extension
table will snap out.
= Change the Presser Foot
To Attach the Extension Table
(for flat-bed sewing)
1. Insert the tab and the pin into their
catches.
2. With your thumb and index finger,
gently snap in.
I
The lid of the accessory storage Use the correct presser foot for
box lifts open toward you. the stitch you wish to sew,
Sewing accessories are conveni-
To change the various presser
ently located in the box.
feet, raise the presser bar to its
highest position by lifting the
presser foot lever.
Loosen the presser foot thumb
screw, choose the proper foot,
insert from the bottom.
Tighten the screw using the
large screw driver to make
certain the foot is secure.
Choose the Needle and Thread
• To Change the Needle
Flat
side
away
from
you
o
Needle clamp screw
J
NOTE: Raise the needle bar to its highest
position by turning the hand wheel
toward you
1. Loosen the needle clamp screw by
turning it toward you.
2. Remove the needle by pulling it down-
ward.
3. Insert the new needle into the needle
clamp with the flat side away from you.
4. Push the needle up as far as it will go.
5. Tighten the needle clamp screw firm y
with the large screwdriver from the
accessor y box.