Setting Stitch Width - Kenmore 15/I649 Instructions Manual

ZIGZAG CONTROL
SETTING STITCH WIDTH
Insert disc # IA Turn the stitch width knob to the desired
setting between 0 and 4 on the knob Zigzag stitch width
increases from 1 to 4, Straight stitching is done with stitch
width control on O setting and by remova| of pattern disc
INSERTING PATTERN DISC
1 Turn hand wheel so that the needle is in its highest position
2 Pull pattern disc shaft cover open
3 Push cam follower release lever _, to the right and keep it there
during insertion
4 Grasp pattern disc and s_ip disc onto the shaft Make sure the
retaining pin _ enters hole in disc To start a pattern at the
beginning, align the white dot on the disc with the cam follower
_ To do this, slip the disc onto the shaft so the white dot is at
or as near (counterclockwise) tbe cam foIlower as possible If
the white dot is not aligned with the cam follower, turn the hand
wheel toward you until the dot is aligned (if the machine is
threaded, be sure to place a scrap of fabric under the presser foot)
5 To remove the pattern disc, follow steps 1 and 2, grasp disc and
pult from shaft
There are two different patterns on each disc A picture of each
pattern is on the disc surface Position disc into machine with
desired pattern facing up
t6
i¸ i ¸