Intended use Remove adjusting keys and wrenches Your Black & Decker hedgetrimmer has been designed for Always check that adjusting keys and wrenches are removed trimming hedges, shrubs and brambles. from the tool before operating the tool. This tool is intended for consumer use only. Extension cables Before use, inspect the extension cable and replace if Safety instructions...
Electrical safety Additional safety instructions for Australia and This tool is double insulated; therefore no earth wire New Zealand is required. Always check that the power supply This appliance is not intended for use by young or infirm corresponds to the voltage on the rating plate. persons without supervision.
Make sure the handle clicks and locks into the front Take care to avoid any foreign objects. Especially avoid handle release buttons (4). hard objects such as metal wire and railings, as these could damage the blades. Connecting the tool to the mains Regularly oil the blades.
Troubleshooting EC declaration of conformity If the tool does not operate correctly, check the following. GT524/GT535/GT545 Black & Decker declares that these products conform to: Fault Possible cause Action 98/37/EC, 89/336/EEC, 73/23/EEC, EN 50144, EN 55014, Tool will not start.