3-9 Air Filter
1) Remove filter cover to turn counterclockwise about 30
degree.
2) Remove old air filter from filter cover. Install new air filter
in filter cover to see "FRONT"
3) FIlter cover put on multi duct inposition, And turn air filter
clockwise about 30 degree.
3-10 MAIN PCB
WARNING : Unplug the refrigerator before removing the
control board.
1) Remove 3 screws on the PCB cover.
2) Remove the PCB cover
3) Disconnect wire harness and replace the main PCB in
the reverse order of removal.
3-11 DISPENSER COVER DISASSEMBLY
Hold the bottom of the
dispenser and pull out
from the door foam.
CAUTION: When replacing the dispenser cover, be
careful that the lead wire in not exposed and the water
tube is not pinched by the dispenser cover, as shown in
the picture below.
PCB Cover
- 13 -