Water Kit Installation Instructions - MULTIQUIP SideWinder HS62A Operation And Parts Manual

HS62A CUT-OFF SAW — WATER KIT INSTALLATION INSTRUCTIONS
Figure 9. Water Kit Parts
Figure 10. Water Kit Assembly Points
Figure 11. Wet Air Filter Canister
HS62A CUT-OFF SAW — OPERATION & PARTS MANUAL — REV. #0 (10/20/06) — PAGE 17
Contents of Water Kit
The contents of the Water Kit cannot be purchased seperately.
See Water Kit Assembly in Parts Section of this manual for
Water Kit part number.
Hose Clamp
Socket Head Cap Screw w/ Washer
Quick Disconnect Fitting
Water Hose
Hex Key Tool (Included with Tool Kit)
Plastic Ties
Wet Air Filter Canister
Water Kit Installation Procedure
Connect the Quick Disconnect Fitting
single end of the Water Hose
Snap fit the Water Hose Outlets
Blade Guard . Orient the Water Hose
Front Handle.
Loop the Hose Clamp
and fasten the clamp to the Roller Bar Support Arm
using the Socket Head Cap Screw w/ Washer
Hex Key Tool .
Use the Plastic Ties
the hose fittings and water hose to the saw.
When using the Water Kit option for your saw, the Dry Air
Filter Canister MUST be replaced with the Wet Air Filter
Canister (See Air Filter Kit Assembly in Parts
Section of this manual).
(Sold Seperately)
to the
.
to the Holes in the
through the
around the Water Hose
as preferred to further secure
, and