Table of Contents
Advertisement
Automatic Icemaker and Ice & Water Dispenser
How it Works
Your refrigerator has
an automatic icemaker
and a dispenser that
dispenses water, ice
cubes and crushed
ice (on some models)
through the freezer
compartment door
Here's how they work
Water flows from the
household
supply
through
a
(1) dual solenoid valve to the
(2) water tubing and to the
(3) automatic icemaker as needed
Water is frozen in the
(4) cube mold and ejected into the
(5) storage bin where a motor-powered
auger moves
cubes forward
Cubes dispense through the chute in the door when the
pad is pressed
When the switch is moved to CRUSHED Ion some
models), a baffle channels cubes through the crusher
and crushed ice falls through a chute into the glass
Water flows through
the
(6) tubing in the door and is dispensed when the pad
is pressed,
(7) A light switch (on some models) turns the night tight in
the dispenser on or off, The light also comes on when the
pad is pressed
The light in the dispenser should be replaced with a
7 watt maximum bulb when it burns out
Important
Facts about
Your Ice & Water
Dispenser
o If this is your first icemaker you'll
hear occasional
sounds that may be unfamiliar.
These are normal
icemaking sounds and are not cause for concern
° Your icemaker will produce
eight cubes per cycle-
approximately
] 20 cubes in a 24-hour period-
depending on freezer compartment temperature,
room temperature, number of door openings and
other use conditions
° Intermittent
dispensing of ice is normal, if ice flow
interruption is more than brief, ice clump(s) may be the
cause and should be removed following instructions in
this section
° Avoid over filling
glasses with ice and using
narrow
or extra-tall
glasses. This can jam the chute
or cause the door in the chute to freeze shut.
Periodically open the freezer compartment door and
took down into the chute If ice is blocking the chute,
poke it through with a wooden spoon_
° To help keep bits of ice from being sprayed
beyond
the glass, place the glass close to the ice
chute-but
not so close that it blocks out coming ice,
* Ice should not be dispensed
into thin glasses, fine
china or delicate crystal-they
can crack or chip
from the combined pressure of your hand pressing
them against the pad and ice dropping into the
container
Fill glasses with ice before
adding
soda or other
beverage
mixes° This will prevent splashing which
could cause the ice and water selector switch to stick,
• Beverages
and foods should
not be quicbchilled
in the ice storage bin. Cans, bottles or food
packages in the storage bin may cause the icemaker
or auger to jam,
° Do not add ice from trays or bags to the storage
bin. It may not crush or dispense well
Before Using Your Icemaker and Dispenser
If you use your refrigerator before the
water connection is made, raise the
ice access door and make sure the
icemaker feeler arm is in the STOP
(up) position,
ler arm in
Feeler arm in
STOP (up)
ON (down)
position
position
When the water supply has been connected to the
icemaker, move the feeler arm to ON (down) position,
Select WATER then press the dispenser pad for about _o
minutes to remove trapped air from the water line and to
fill the water reservoir The ice cube mold automatically
fills with water after cooling to freezing temperatures First
cubes normaily freeze after severat hours
NOTE: With a newly-installed refrigerator,
allow about
24 hours for the freezer compartment to cool down to
the proper ice-making temperature
Advertisement
Table of Contents
