Kenmore 57278 Owner's Manual page 13

Fittheendoftheplastic
drawersupport i ntothe
slotonthegasket, withthe
rubbergasket f lapfacing
you Makesure thegasket
snaps intoplace,
Aftercleaning, replace drawers andcovers inreverse
order.Relnstall thegasket a ttherearofthetopdrawer.
Drain Opening in Freezer Compartment
When cleaning, remove
the freezer bin and flush
a solution of baking soda
(one teaspoon) and two
cups of hot [not boiling)
water through the drain
line with the help of a
meat baster This will
help eliminate odor and
I
reduce the likelihood of a clogged drain line
If drain becomes clogged, use a meat baster and
baking-soda-and-water solution to force the clog through
the drain line.
Condenser
The condenser is located
behind the base grille For
most efficient operation,
remove the base grille and
sweep away or vacuum
up dust that is readily
accessibte. For best
results, use a brush specially
designed for this purpose_ It is available at your Sears
slore or service cenler,, This easy cleaning operation
should be done at lea#once a year,
Behind Refrigerator
Take care moving your refrigerator away from the wall
All types of floor coverings con be damaged, particularly
cushioned coverings and those with embossed surfaces,
Pull the refrigerator straight out and return it to position by
pushing it straight in Moving refrigerator in a side direction
may damage floor covering or refrigerator.
Light Bulb Replacement
Unplug the refrigerator before changing a light bulb.
Fresh Food Compartment--Upper Light
1. Unplug refrigerator°
2. Pull off temperature control knobs,
3, Pull the bottom of the light shield down and forward,
then rotate the top up and off
After replacing with same size bulb, reinstall light shield
Fresh Food Compartment--Lower Light
This light is located behind a shield at the rear of
the fresh food compartment
1, Grasp the top edge of the shield and lift it up
and forward to free its top edge,
2. After replacing with same size bulb, hook the top
of the shield back in place.
Freezer Compartment
1_ Remove shelf
just
below
light panel. [Shelf will be
easier to remove if it is
emptied first )
2. Pull plastic light panel
!oward you (It will bend to
free tabs from grooves )
3. After replacing with same size bulb, reinstall panel
and shelf
13