Advertisement
DOOR REMOVAL
If door must be removed:
,, Unplug the unit
,, Gently lay refrigerator on its back, on a rug or blanket•
,, Remove two base screws and base panel• Remove wire from
clips on bottom of cabinet, if required•
,, Unplug connector, if required, by holding the cabinet connector
in place and pulling the door connector out.
,, Remove the bottom hinge screws•
,, Remove the plastic top hinge cover•
,, Remove the screws from the top hinge•
,, Remove the top hinge from the cabinet•
,, Remove the door and bottom hinge from the cabinet•
,, To replace door, reverse the above procedures and securely
tighten all screws to prevent hinge slippage•
Base
BasePanel Screws
iNTERiOR LiGHTiNG
The light comes on automatically when the door is opened• The
light bulb assembly is located on the back of the refrigerator
control box. To replace the light bulb, turn the temperature control
to "OFF" and unplug the electrical cord. Replace the old bulb
with a bulb of the same type and wattage.
Hinge Screws
SPILL PROOF SLIDE=OUT GLASS SHELVING
Multi-position
adjustable slide out glass shelves can be moved
to any position
for larger or smaller packages• The shipping
spacers that stabilize the shelves for shipping may be removed
and discarded•
"-\
Cabinet
Connector
COOL DOWN PERIOD
For safe food storage, allow four (4) hours for refrigerator to cool
down completely• The refrigerator
will run continuously
for the
first several hours•
ELECTRONIC
TEMPERATURE
CONTROL
The electronic
temperature
control
is located
inside
the
refrigerator• Temperature is factory preset to provide satisfactory
food storage temperatures•
However, the temperature control is
adjustable to provide a range of temperatures
for your personal
satisfaction• To adjust the temperature setting, move the UP (A)
button for warmer temperature and DOWN (Y) button for colder
temperature
on the control panel• Allow several hours for the
temperature
to stabilize between adjustments•
FRDGETEMP
7 is coNest
O is off
TO ADJUSTTHE
SHELVES
®
®
®
Lift front edge up.
Pull shelf out
Replace the shelf by inserting the hooks at rear of the shelf into
the wall bracket• Lower the shelf into the desired slots and lock
into position•
Advertisement
