Preparation; Attaching The Stand Unit - Sharp LC-46LX650H Operation Manual

Preparation

Attaching the stand unit

• Before attaching (or detaching) the stand, unplug the AC power cord from the AC power outlet.
• Before performing work, spread cushioning over the surface on which you will be laying the TV. This will prevent it from being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
H LC-46LX650H/LC-52LX650H
Step 1 below is only applicable to LC-46LX650H
1 Insert the supporting post into the foam blocks
1
TOP-L and TOP-R , as shown in the figure
below.
2 As illustrated in the following figure,attach the
supporting post onto the stand.
3 Insert the eight screws into the eight holes on
the bottom of the stand, and tighten them.
• To install the stand correctly, hold the stand
with one hand securely, and tighten the
screws with the other hand.
Step 1 below is only applicable to LC-52LX650H
1 Insert the supporting post into the foam block
1
TOP-L, as shown in the figure below.
2 As illustrated in the following figure, attach the
supporting post onto the stand.
3 Insert the eight screws into the eight holes on
the bottom of the stand, and tighten them.
• To install the stand correctly, hold the stand
with one hand securely, and tighten the
screws with the other hand.
12
TOP-L TOP-R
FRONT
TOP-L
FRONT
Insert the base into the slot on the bottom
2
of the TV(while holding the base to avoid it
falling over).
Soft cushion
Insert the four screws into the four holes on
3
the back of the TV, and tighten them.
NOTE
• When installing the stand, you need to put your TV on a flat
surface. Before that, put a soft cushion on the surface.
• The angle of the stand is not adjustable.
• To detach the stand unit, perform the steps in reverse
order.
• A screwdriver is not supplied with this product.
• During installation, please be careful to avoid getting your
hand trapped between the TV bottom and the floor.