Ignition System; Burner Flame Pattern - Weber PERFORMER 78763 Owner's Manual

20
PERIODIC QUICK CLEANING
We recommend that you periodically brush the
outside of the burner slots with a brass wire brush and clean the burner tube
through the combustion air vent with the tool we have provided.
This can be done by locating the burner combustion air vent (1) underneath
the bowl bracket and inserting the tool through each combustion air vent,
rotating the tool. Be careful when inserting the burner cleaning tool not to
damage the igniter electrode.
CAUTION: It is important to increase the frequency of
this cleaning procedure during the spring and summer
months.

IGNITION SYSTEM

If the Ignition System fails to ignite the burner, light manually. If Manual igni-
tion is successful, then check the Ignition System.
• Check that both the white (2) and black (3) ignition wires are attached
properly.
• Check that the igniter button pushes in completely and returns.
• Check to see if the igniter is loose in the frame. Tighten if necessary;
see Step "Install Igniter" (Pg.11, Step 9B) for the correct procedure.
If the Ignition System still fails to ignite the burner, use the Manual Lighting
procedure and contact your dealer.

BURNER FLAME PATTERN

The burner has been factory set for the correct air and gas mixture. The cor-
rect fl ame pattern should have yellowish tips (4) dark blue in the middle (5),
and light blue at the burner tube (6). If the fl ames do not appear as shown, or
if "popping" noises occur, follow the burner cleaning procedures.
NorthlineExpress.com
MAINTENANCE
http://www.northlineexpress.com
(2)
(4)
(5)
(6)
(1)
(3)
Toll-Free 1-866-667-8454