Maintaining The Electronic; Crossover Ignition System - Weber Spirit PREMIUM E-310 Owner's Manual

Hide thumbs Also See for Spirit PREMIUM E-310:
Table of Contents

Advertisement

MAINTAINING THE ELECTRONIC

CROSSOVER IGNITION SYSTEM

The igniter module supplies power to the electronic
Crossover ignition system and the side burner with one
igniter button . Whether you are performing routine
maintenance or a troubleshooting check on the ignition
system, read the following to keep your ignition system
working properly .
If the electronic Crossover ignition system fails to ignite,
you'll need to pinpoint where the problem is occurring:
with the gas flow or with the electronic ignition system .
Begin by attempting to match light your burners . Refer
to "MAIN BURNER IGNITION - Lighting with a Match . "
If match lighting is successful, the problem lies in the
ignition system .
Verify that the AA battery (alkaline only) is in good
condition and is installed correctly (1) . Some batteries
have a plastic protective wrap around them . This
plastic must be removed before installing battery . Do
not confuse this plastic with the battery label .
Make sure the igniter wires are properly attached to
the igniter module . Refer to the "IGNITOR MODULE
WIRE GUIDE" chart on this page .
Make sure the ceramic igniter assembly is fully
inserted into burner tube igniter channel (2) . If
properly positioned, you will hear a snap (3) .
Make sure the electronic igniter button is working by
listening for clicking and looking for sparks at burner .
If the electronic Crossover ignition system still fails to
ignite, contact the Customer Service Representative
in your area using the contact information on our web
site. Log onto www.weber.com.
26
WWW.WEBER.COM
ROUTINE MAINTENANCE
IGNITOR MODULE WIRE GUIDE (E-210, E-310)
4
3
2
1
BURNER 1
Black Terminal (1)
Yellow Terminal (2)
2
3
1
IGNITOR BUTTON
Black Terminal (3)
Black Terminal (4)
2
1
3
4

Advertisement

Table of Contents
loading

Table of Contents