Ptz Control - OCB -DVR700 User Instruction Manual

PTZ Port: 2U Case D1 model and 2U Case CIF model, select a port for PTZ connection.
RS-485 parameters: Including baudrate, data bit, stop bit, parity bit, flow control, etc. These parameters
must be the same as those of PTZ Protocol.
PTZ Addr: Each PTZ has one different address.
Protocol: DVR had the following PTZ protocol: PELCO-D PELCO-P2 PELCO-P1 W110 P3 PLD
ENKEL YAAN SONY JC4116 PD-NW PD-CONST PIH-1016 KRE301 PELCO9760 LILIN
T3609HD HD600 KTD SAMSUNG ELEC PANASONIC FASTRAX DL-0001.
Speed: PTZ turning speed.
Rotate: When you set the PTZ is continuous send command.
Vertical: Reverse PTZ's vertical field.
Horization: Reverse PTZ's horizontal field.
Setup is finished, you can select the menu below the "copy", and the parameter will be set to another channel.

PTZ Control

After the PTZ parameter is set, press "PTZ" key on front panel to enter PTZ control mode.
Fig. 15
25