OCB -DVR700 User Instruction Manual page 16

1.5U model PTZ linkage should be as follows:
Each camera press shown connection is completed, go to the Main Menu — PTZ Setup — PTZ menu, select
Connect head's port number, and you can set the camera's head address, baud rate and head a protocol parameters.
2UCaseD1model and 2UCaseCIFmodel need to choose the port number RS485(1) or RS485(2)
WARNING: PLEASE SET ALL OF THE PTZ ADDRESSES DIFFERENTLY.
After the setup, click "PTZ" on the shortcut menu to enter the PTZ control interface.
Fig. 6
Fig. 7
15