Kenmore Elite 79075353314 Installation Instructions Manual

Advertisement

Available languages

Available languages

Quick Links

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
PNAS |f the information in this manual is
not followed exactly, a fire or explosion may
result causing
property
damage,
personal
injury or death.
FOR YOUR SAFETY:
Do
not store
or use
gasoline
or other
flammable
vapors
and
liquids
in the
vicinity of this or any other appliance.
WHAT TO DOIF YOU SMELL GAS:
* Do not try to light any appliance.
* Donottouch any electrical switch; do not
use any phone in your building.
* Immediately call your gas supplier from
a neighbor's
phone.
Follow
the
gas
supplier's instructions.
¢ If you cannot reach your gas supplier, call
the fire department.
Installation andservice must be performed
by a qualified installer, service agency or
the gas supplier.
IVAN)
Tip Over Hazard
e A child or adult can tip the
range and be killed.
® Verify the anti-tip device has
been installed to floor or wall.
e Ensure the anti-tip device is re-engaged to floor
or wall when the range is moved.
® Do not operate the range without the anti-tip
device in place and engaged.
® Failure to follow these instructions can result in
death or serious burns to children and adults.
¥
&e
©
Range
SQ
leveling leg .
1 )
antict
ncaa
ao
nti-tip
Ze
bracket
To check if the anti-tip bracket is installed properly, use
both arms to grasp the rear edge of the range back.
Carefully attempt to tilt range forward. When properly
installed, the range should not tilt forward.
Refer to the anti-tip bracket installation instructions
supplied with your range for proper installation.
Refer to your serial plate for
applicable agency certifications
Clearances and Dimensions
Location: Check location where the range will be installed.
Check for proper electrical and gas supply, and the stability
of the floor.
Dimensions that are shown must be used. Given
dimensions provide minimum clearance. Contact surface
must be solid and level.
£28713/32"
—~A maximum
door
closed
3641/8"
44.5/8"
maximum
door
open
a
a
Provide Proper Fuel Type
Before proceeding: Your range is factory preset to operate on
natural gas. If L.P. conversion is needed, contact your local
L.P. Gas provider for assistance.
The L.P. conversion
kit may be located on the lower rear
back panel of the range. If no L.P. kit is provided, contact
your product dealer to obtain the correct L.P. conversion kit.
PN 316454928 RevA
(1206)

Advertisement

Table of Contents
loading

Table of Contents