Pride Quantum Series Owner's Manual page 26

V . C O M F O R T
Anti-Tip Wheels
The anti-tip wheels are designed to give your power chair increased stability on rough surfaces. The anti-tip wheels are
preset for smooth surfaces or indoor use only. If you plan on using your power chair on rough surfaces, it may be
necessary to adjust the anti-tip wheels to better suit your needs. The anti-tip wheels may need adjustment if either of the
following occur:
! When coming to a stop, your power chair tips forward excessively.
! The anti-tip wheels constantly rub the ground.
WARNING! Consult your Quantum Rehab Specialist before attempting to change the anti-tip wheel
height! Changing the anti-tip wheel height affects handling under deceleration!
WARNING! The higher you raise the anti-tip wheels, the more you increase your power chair's
tendency to tilt forward when coming to a stop. You can compensate for this by having your
Quantum Rehab Specialist make a small adjustment to the pre-programmed deceleration setting
in the controller or by moving the seat assembly further to the rear of your power chair.
PROHIBITED! Do not remove the anti-tip wheels.
To adjust the anti-tip wheels:
1. Remove the anti-tip wheel.
2. Remove the nut and bolt on the anti-tip bracket. See
figure 22.
3. Raise or lower the anti-tip wheel.
4. Reinstall the nut and bolt on the anti-tip bracket.
5. Reinstall the wheel.
6. Raise or lower the other anti-tip bracket so that it is at the
same height.
NOTE: Each drive tire must have 35 psi (2.4 bar) in
order for the anti-tip wheels to be properly adjusted.
26
A D J U S T M E N T S
ANTI-TIP WHEEL BRACKET
ANTI-TIP WHEEL
Figure 22. Anti-Tip Wheel Assembly
www.quantumrehab.com Quantum 1121 Series