Pride Quantum Series Owner's Manual page 23

V . C O M F O R T
Armrest Width Adjustment
You can change each armrest's width independently of
each other.
NOTE: Changing the armrest width may increase the
overall width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the armrest
receiver bracket. See figure 15.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Armrest Height Adjustment
To change the armrest height:
1. Loosen the two setscrews located on the armrest receiver.
2. Raise or lower the armrest to the desired height. See
figure 15.
3. Tighten the setscrews to secure the armrest.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to the
floor.
2. Loosen the jam nut. See figure 15.
3. Loosen the armrest angle adjusting screw.
4. Turn the adjustment screw to raise the front of the armrest or
to lower the front of the armrest. See figure 15.
5. Tighten the jam nut to lock the adjusting screw into place.
Controller Position
You can mover the controller in toward or out away from
the armrest, or change the position of the controller for ei-
ther left-hand or right-hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the seat
frame or the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See figure 16.
3. Slide the controller into or out of the armrest to the desired
position.
Quantum 1121 Series
A D J U S T M E N T S
JAM NUT
ARMREST ANGLE
ADJUSTING SCREW
ARMREST HEIGHT
ADJUSTING
SETSCREWS
SEATBACK ANGLE
ADJUSTING SCREW
ARMREST KNOB
Figure 15. Seatback and Armrest Adjustments
Figure 16. Controller Adjustment
www.quantumrehab.com
CONTROLLER BRACKET
SETSCREW
23