Pride Quantum Series Owner's Manual page 24

V . C O M F O R T
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller connector from the power base.
3. Remove any wire ties securing the controller cable to the
armrest.
4. Flip up the armrest so it is perpendicular to the floor.
5. Loosen the setscrew on the controller bracket
6. Slide the controller out of the armrest.
7. Loosen the setscrew in the other armrest.
8. Place the controller in the other armrest.
9. Tighten the setscrew to secure the controller.
10. Route the controller cable to the back of the power base and
plug in the controller.
11. Secure the controller cable to the armrest with wire ties.
NOTE: If your power chair is equipped with a Spe-
cialty Seat, Synergy Seat, or TRU-Balance Power Po-
sitioning System, loosen the mounting screws in the
mounting block, transfer the mounting block and con-
troller to the opposite armrest, and tighten the mount-
ing screws. See figure 17 .
Foot Platform Height Adjustment
The foot platform height is easily adjusted to one of several
different heights.
To raise or lower the foot platform:
1. Remove the nuts and bolts from the foot platform bracket.
See figure 18.
2. Raise or lower the foot platform to the desired height.
3. Reinstall the nuts and bolts into the foot platform bracket and
tighten.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the nuts and bolts from the foot platform bracket.
See figure 18.
2. Move the foot platform in or out to the desired depth.
3. Reinstall the nuts and bolts into the foot platform bracket and
tighten.
24
A D J U S T M E N T S
SETSCREWS
Figure 17. Controller Position Mounting Bracket
BALL DETENT PIN
Figure 18. Foot Platform Height Adjustment
www.quantumrehab.com
MOUNTING
SCREWS
FOOT PLATFORM BRACKET
NUTS AND BOLTS
Quantum 1121 Series