Setting Oven Controls - Kenmore 790.4662 Use & Care Manual

Setting Oven Controls
Setting the Clock
The CLOCK _ pad is used to set the clock. The dock may be set for 12 or 24 hour
time of day operation. The clock has been preset at the factory for the 12 hour
operation. When the range is first plugged in, or when the power supply to the range
has been interrupted, the timer in the display will flash with "PF" (power failure, See
Figure 1).
When PF appears in the display, press @. No sound will be heard, but after 10 seconds
a beep will sounds and PF will disappear.
INSTRUCTIONS
To set the clock (example: 1:30)
1. Press _. "CLO" will appear in the display (Figure 2).
2.
Press (,1_ _ (_0_ pads to set the time of day to 1:30
"CLO" will stay in the display. Press _.
(Figure 3).
"CLO" will disappear and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1. Press and hold _ for 7 seconds (Figure 3). While holding
the pad down the current time of day will remain and "CLO"
will disappear from the display (Figure 4). CONTINUE holding
the pad until "12Hr" (Figure 5) or "24Hr" (Figure 6) appears in
the display.
2. Press _ to switch between the 12 and 24 hour time of day
display. The display will show either "12Hr" (Figure 5) or
"24Hr" (Figure 6).
3. Press <A_ to accept the desired change or press @ to
reject the change.
4. Reset the correct time as described in To set the Clock
above. Please note that if the 24 hour time of day mode was
chosen, the clock will now display time from 0:00 through
23:59 hours.
PRESS
Q
OQQ
Q
for 7 seconds
Figure 1
DISPLAY
Figure 2
Figure 3
/
Figure 4
Figure 5
Figure 6
15