Whirlpool Room Air Conditioner Use & Care Manual page 12

Figure 26
-RAIL SEAL I
DRAIN CUP ASSEMBLY
INSERT INTO
NOTE: During high
humidity, condensate
may drip from the
outside of your air
conditioner onto Ihe
ground below. If your
air conditioner is installed
where this is undesirable,
you can direct the waler
IO a more suitable spol
by using some flashing
or other similar means.
17
l
Apply seal strip to top of unit flange
as shown
in figure 27. Plug two crating bolt holes (l/4"
diameter) with gum sealer to prevent water
dripping from these holes (see Figure 27).
Figure 27
CRATING
BOLT HOLE
DRAIN HOLE
(DO NOT PLUG)
CRATING
BOLT HOLE
1.8.
Insert air conditioner into cabinet.
Slide air
conditioner only three-fourths of the way
into the cabinet.
Do not push against sharp
fins and plastic parts. Apply 518"-thick
seal strip onto bottom of base of air con-
ditioner as shown in Figure 28. Now push air
conditioner al! the way into cabinet being
sure angle bracket on base clears bottom
front edge of cabinet. Again, do not push
against sharp fins and plastic parts. Attach
green ground wire to the left-front corner of
unit base by using ground wire screw (see
Figure 28).
(CAUTION: KEEP WIRE CONNECTED
WHENEVER AIR CONDITIONER
IS IN
CABINET. IT IS THERE FOR YOUR
ELECTRICAL SAFETY DURING OPERA-
TION AND MAINTENANCE.)
Figure 28 FLANGE SEAL
/
GROUND
WEATHER
WIRE SEAL
UPWARD
ANGLE BRACKET
ON BASE
19
. Attach front panel
by placing bottom edge on
clips and pushing top down, then in and up.
Installation
Instructions
CAUTION:
l
Be sure air conditioner does not fall during
installation.
12