Volvo Penta TAMD60A Instruction Book page 46

44
Fig. K2B. Wiring diagram
TAMD70C*, TAMD70D, AQD70C*,
AQD70D
1. Batteries. For capacity see 'Tech.
data".
2. Master switch
3. Starter motor
4. Alternator
4x. Alternator (1600 W, optional
equipm.)
5. Voltage regulator
5x. Voltage regulator (optional equipm.)
Must not be fitted to engine.
6. Fuses 50 A for standard alternator
(80 A for 1600 W alternator)
7. Fuses 25 A (in both cases)
8. Oil pressure sender, engine
9. Stop solenoid
10. Engine coolant temperature sender
11. Oil pressure sensor (for hour
meter)
12. Speed sender
13. Oil pressure sender -- reverse gear
14. Oil pressure sensor
15. Pressure sender, turbo
16. Engine coolant temperature sensor
17. Relay box for air pre-heater
18. Solenoid valve
19. Flame glow plug
20. Starter cut-out relay (only
TAMD70D, AQD70D)
*TAMD70C, AQD70C engines:
Cables from terminal 105 connect to
the starter motor terminal 50 and to the
relay box terminal 4. The cable from
terminal 110 goes directly to the alter-
nator terminal 61.
If the large alternator is used (1600 W)
a cable connects directly from the vol-
tage regulator terminal WL to terminal
110.