Installation Instructions; Oven Diagram - Sharp Carousel R-210H Operation Manual

A38694, SCA/SCNZ R210H O/M

INSTALLATION INSTRUCTIONS

1. Remove all packing materials from the oven cavity and the feature sticker from the outside of the door, if there
is one. Check the unit for any damage, such as a misaligned door, damaged door seals around the door or
dents inside the oven cavity or on the door. If there is any damage, please do not operate the oven until it
has been checked by a SERVICE CENTRE APPROVED BY SHARP and repaired, if necessary.
2. Accessories provided
1) Turntable 2) Roller stay
3) Operation manual and Cooking guide
3. Locate the roller stay in the centre of the oven, then fit the turntable on the roller stay. Make sure the turntable
and roller stay are centrally located and locked together. Refer to OVEN DIAGRAM below. NEVER operate
the oven without the roller stay and turntable.
4. The oven should not be installed in any area where excessive heat and steam are generated, for example,
next to a conventional oven unit. The oven should be installed so as not to block ventilation openings. When
mounting on bench top : Allow at least 10cm on the top, 5cm on the both sides and at the rear of the oven
for adequate air circulation.
5. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or
personal injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage must be single phase 230 – 240V, 50Hz.
6. Operate the oven from a general purpose domestic outlet.
If a generator is used, do not operate the oven with non-sinusoidal outputs.

OVEN DIAGRAM

6
3
4 5
1. Door open button
2. Oven lamp
3. Door hinges
4. Door safety latches
5. See through door
6. Door seals and sealing surfaces
7. Coupling
2
8
1
7 9 4
4
q
w
0
e
8. Control panel (See page 5)
9. Waveguide cover (Do not remove)
10. Power supply cord
11. Ventilation openings
12. Turntable
13. Roller stay
14. Rating plate
r