Operating The Tv With The Remote Control; Troubleshooting Chart - Sharp HT-SB602 Operation Manual

Operating the TV with the remote
control
You can operate Sharp TVs with this system's remote
control.
 Watching TV
Point the remote control at the TV.
1
Press the TV (
on the TV.
2
Pressing the TV CH + or – button enables TV
channel switching.
3
Press the TV VOL + or – button to adjust the TV
volume.
Other operable button
Input Select Button
Mute (TV)
AV mode
) ON/STANDBY button to turn

Troubleshooting chart

Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following
before calling your authorized SHARP dealer or service centre.
 General
Symptom
 No sound is heard.
 The sound from
subwoofer is not
well balanced.
 Power turns off
suddenly.
 Noise is heard
during playback.
 When a button
is pressed, the
sound bar does not
respond.
 The power is not
turned on.
 3D images not
displayed on the
TV.
 Background noise
appears when
connecting with
RCA audio output
terminal connection
from a TV-set/
DVD/Blu-ray Disc
Player.
 Wireless
connection cannot
be established.
E-17
Possible cause
 Is the input signal (selection) set
properly?
 Is the volume level set to "MIN"?
 Is muting activated?
 Is HDMI compliant equipment
being used?
 Is the HDMI cable connected
correctly?
Connect the HDMI cable correctly
and then perform the reset
procedure. (refer page 18)
 Do not connect or disconnect
an HDMI cable whilst power is
on. This may lead to operation
problems.
 Is the subwoofer level set to the
minimum or maximum level?
 Is the HDMI cable connected
correctly? Connect the HDMI
cable correctly and then perform
the reset procedure.
 Move the speaker away from any
computers or mobile phones.
 Set the sound bar to the standby
mode and then turn it back on.
 Is the sound bar unplugged?
 The protection circuit may be
activated. Unplug and plug in the
power lead again after 5 minutes
or more.
 Depending on the TV and Video
component, 3D images may not
be displayed.
Check the operation manual of the
respective component.
 HDMI cable not support 3D image.
 Please change to HDMI/ARC or
headphone terminal from TV-Set/
DVD/Blu-ray Disc Player. This
effect may occur depending on
TV/DVD/Blu-ray Disc Player-
Brand, model and age, and it is
not the sound bar problem.
 Check the distance between the
sound bar and subwoofer (less
than 10m (32 feet)).
 Make sure there is no other
wireless devices near the unit.