Supplying Electric Power To The Antenna; Initial Auto Installation - Sharp AQUOS LC-32D77X Operation Manual

Preparation
Supplying electric power to the
antenna
When you set-up the DTV antenna for the fi rst time,
or connect the antenna to a community antenna, you
need to proceed to set the antenna by following this
manual.
Press DTV to access DTV mode.
1
Press MENU and the MENU screen displays.
2
Press c / d to select "Setup".
3
Press a / b to select "Antenna setup-DIGITAL"
4
and then press ENTER.
Press a / b to select "Supply voltage" and
5
then press ENTER.
Press c / d to select "On" and then press
6
ENTER.
Selected item
On Select "On" when your antenna is set-up
and connected independently.
Off Select "Off" when you do not need to
supply voltage to your antenna, i.e.
when your antenna is connected to a
community antenna. (The factory default
setting of this function is "Off".)
52D77X.indb 11 52D77X.indb 11
Description

Initial auto installation

When the TV powers on for the fi rst time after purchase,
the initial auto installation wizard appears. Follow the
menus and make the necessary settings one after
another.
Confi rm the following before turning on the
power
• Is the antenna cable connected?
• Is the AC cord plugged in?
Press POWER on the TV.
1
• The initial auto installation wizard appears.
Setting the on-screen display language.
2
Display language settings
Press a / b to select the desired language,
3
and then press ENTER.
Press c / d to select "HOME" or "STORE",
and then press ENTER.
Select the location of TV.
The picture will be optimized for that location.
HOME
• HOME: "STANDARD" will be the default value for
the "AV MODE" setting.
• STORE: "DYNAMIC (Fixed)" will be the default
value for the "AV MODE" setting. If the "AV
MODE" is changed, the TV will automatically
switch back to "DYNAMIC (Fixed)" when there is
no further change to TV setting for 30 minutes.
Press ENTER.
4
Major Analogue Channel settings are pre-set.
However, if there are any channel(s) that you
cannot receive with the factory pre-sets, please
perform "Auto Installation" in "Setup" section
(refer chapter "Watching TV" on manual).
• Major Analogue Channel settings are pre-set.
However, if there are any channel(s) that you
cannot receive with the factory pre-sets, please
perform "Auto installation" in "Setup" section.
(See page 20.)
English
STORE
Digital Search
2/17/09 5:13:03 PM 2/17/09 5:13:03 PM
11